Futaba 10CG 2.4GHz User Manual
Page 91
91
GOAL of EXAMPLE:
STEPS:
INPUTS:
Reverse servos as needed for proper
control operation. Ex: LEFT RUDDER
STICK results in leading edge of tail
rotor blades moving left. Reverse to
operate properly. P. 38.
In the BASIC menu, open REVERSE.
C
to REVERSE.
to choose REVERSE.
Choose desired servo and reverse its
direction of travel. (Ex: reverse rudder
servo.)
C
to CH4:RUDD.
so REV is highlighted.
Are you sure?
Displays.
for 1 second.
Repeat as needed.
to return to BASIC menu.
Adjust Travels as needed to match
model's recommended throws (usually
listed as high rates).P. 39.
In the BASIC menu, choose END POINT.
C
to END POINT.
to choose END POINT.
Adjust the servos’ end points.
(Ex: elevator servo)
Return to BASIC menu.
C
to ELEV.
ELEVATOR STICK.
until up travel is as desired.
ELEVATOR STICK.
until down travel is as desired.
Repeat as needed.
Activate THR-CUT. P. 98.
Open THROTTLE-CUT function.
C
to THROTTLE-CUT.
to choose THR-CUT.
Activate the function. Choose desired
switch and position to activate.
C
to MIX
to OFF.
C
to SW.
to C.
C
to POSI.
to DOWN.
With THROTTLE STICK at idle, adjust
the rate until the engine consistently
shuts off, but throttle linkage is not
binding.
1
Close.
C to down position.
THROTTLE STICK.
C
to RATE.
until shuts off.
Set up throttle curve for normal. (Usually
changes will not need to be made prior
WR¿UVWÀLJKW 3
Open the THR-CURV/NOR function.
Adjust if needed.
Close the function.
C
to THR-CURV/NOR.
.
C
to 1 >.
to 5%.
C
to next point.
Repeat.
Set up collective pitch curve for normal
ÀLJKW:HVXJJHVWDVWDUWLQJSRLQWRI
center of +5,end of +8 to +10 degrees of
blade pitch for aerobatics.
2
(If just learning
WRÀ\DVN\RXULQVWUXFWRU 3
Open the PIT-CURV/NOR function.
Adjust each point to match desired
FXUYH ([ ¿UVWSRLQW 8%.)
Close the function.
C
to PIT-CURV/NOR.
.
C
to 1 >.
to 8%.
C
to next point.
Repeat.
Set up revo. mixing for normal. (For
heading-hold gyros, inhibit revo.) P. 97.
Open the REVO./NOR function.
Adjust to your desired starting point.
(Ex: 10%.)
Close the function.
C
to REVO./NOR.
.
C
to 1 >.
to 10%.
C
to next point.
Repeat.
&RQ¿UP*\URGLUHFWLRQ 1RWH LIXVLQJ
D KHDGLQJKROG$9&6 J\UR XVH WKH
GYRO
programming for proper setup.
See p. 106.)
With radio on, move helicopter’s tail to the right by hand.
The gyro should give right rudder input (leading edge of the tail rotor blades
move left).
If the gyro gives the opposite input, reverse direction on the gyro unit itself.