Futaba FX-40 - Manual (Page 107)

107 <Model Menu (Airplane/Glider Functions)>
0XOWL(QJLQH >&RUUHVSRQGLQJPRGHOW\SH@ $LUSODQHJHQHUDO
This function lets you adjust the throttle when
using a multi engine airplane with up to 4 engines.
The Throttle Cut function, Idle Down function,
Throttle Hold function, High Trim, and Idle Trim
can be adjusted by throttle channel (THR, THR2,
7+57+5 
*Initial setting assigns only one throttle channel (THR).
When using this function, the number of throttle channels
must be assigned beforehand at the Function menu of the
Linkage Menu.
ŏ7KHWKURWWOHFXWSRVLWLRQFDQEHVHWIRUHDFK
throttle channel. Throttle cut operation is linked to
WKHVZLWFKVHWZLWKWKH7KURWWOH&XWIXQFWLRQRIWKH
/LQNDJH0HQX
*The throttle cut position set at this screen is effective.
ŏ5HWXUQWR0RGHO0HQX
ŏ7RXFKWKH>0XOWL(QJLQH@EXWWRQLQWKH0RGHO
0HQXWRFDOOWKHVHWXSVFUHHQVKRZQEHORZ
*The number of engines (1~4) assigned by Function
menu in the Linkage Menu setup screen is
displayed.
ŏ7KHWKURWWOHGRZQRIIVHWUDWHFDQEHVHWIRUHDFK
WKURWWOHFKDQQHO,GOHGRZQRSHUDWLRQLVOLQNHGWR
WKHVZLWFKVHWZLWKWKH,GOH'RZQIXQFWLRQRIWKH
/LQNDJH0HQX
*The idle down offset rate set at this screen is effective.
ŏ2SHUDWLRQFDQEHÀ[HGDWWKHHQJLQHVSHHG
(carburetor opening angle) for each throttle
channel with the Hold Position function. The hold
position can be changed.
ŏ+LJKVLGHWULPDQGLGOHWULPFDQEHVHWIRUHDFK
FKDQQHO2SHUDWLRQDFWVDVKLJKWULPRULGOHWULP
based on the center.
ŏ 7KURWWOH FXW SRVLWLRQ VHWWLQJ IRU HDFK
engine)
ŏ,GOH GRZQ RIIVHW UDWH VHWWLQJ IRU HDFK
engine)
ŏ7KURWWOHKROGSRVLWLRQVHWWLQJ
ŏ+LJK7ULPVHWWLQJ IRUHDFKHQJLQH
ŏ,GOH7ULPVHWWLQJ IRUHDFKHQJLQH