Futaba FX-40 - Manual (Page 129)

129 <Data>
Updating
);WUDQVPLWWHUSURJUDPFDQEHXSGDWHG:KHQIXQFWLRQVDUHDGGHGRULPSURYHGWKHXSGDWH¿OHFDQEH
GRZQORDGHGIURPRXUZHEVLWH&RS\WKHXSGDWH¿OHVWRWKH&)FDUGDQGWKHQXVHWKHIROORZLQJSURFHGXUHWR
update the program.
Updating procedure
Note: If the battery fully discharges during
program updating, updating will fail. When
WKH UHPDLQLQJ EDWWHU\ FDSDFLW\ LV  RU
less, always recharge the battery before
updating.
Note: The model data in the transmitter will not
be changed after updating, but to be safe,
back up the model data before updating.
Normal operation mode
Update mode
Update switch
Card slot
,QVHUWWKH&)FDUGFRQWDLQLQJWKHXSGDWHÀOH
into the card slot.
 8VH WZHH]HUV WR VZLWFK WKH VOLGH VZLWFK
(update switch) at the side of the card slot in
the up direction.
 7XUQ RQ WKH WUDQVPLWWHU SRZHU $ERXW 
seconds later, the screen shown below will
appear. To abort updating, turn off the
transmitter power.
1RWH ,ID&)FDUGLVQRWLQVHUWHGLQWRWKHFDUG
VORWRUWKHÀOHVQHHGHGDUHQRWFRSLHGWRWKH
&)FDUGWKHHUURUPHVVDJHVKRZQEHORZZLOO
appear. Turn off the power to the transmitter
DQGFKHFNWKH&)FDUG
4. When the rotary switch is pushed, updating
starts. During updating, the bar graph moves
to the right.
 :KHQ XSGDWLQJ LV FRPSOHWH WKH VFUHHQ
shown below appears.
7XUQRIIWKHSRZHUVZLWFK$IWHUWKHPRQLWRU
LED goes off, switch the update switch in the
down direction.
 $ I W H U  W K H  X S G D W L Q J  D E R Y H  K D V  E H H Q
completed, turn on the power and then
check the system program version at the
system menu information screen.