Futaba FX-40 - Manual (Page 16)

16 <Before Use>
Digital trim
This transmitter is equipped with 8 digital trims.
Digital trims T1~4, T7, and T8 are rotary type and
digital trims T5 and T6 are lever type. When the
trim position is at the center, the tone will change.
The trim position is graphically displayed on the
home window at all times.
Each time T5 and T6 is pushed; the trim position
FKDQJHVD¿[HGVWHSDPRXQW,IDWULPEXWWRQLVKHOG
down, the trim position starts to change faster.
Note: The trim positions you have set will be stored in the
non-volatile memory and will remain there.
Touch Panel/ Rotary Key/ Direct Key
Ɣ'LUHFW.H\
Ɣ5RWDU\.H\
Ɣ/&''LVSOD\
 7RXFK3DQHO
66
Touch panel, rotary keys and direct keys are used
for entering data.
Touch Panel
7RXFKWKHSDQHOZLWK\RXU¿QJHURUWKHDWWDFKHG
stylus pen, which is also used as a toolbox, to enter
data.
Caution
Touch softly the Touch Panel with the stylus
SHQRU\RXU¿QJHUWLSV
or
Never use your finger pad to push the Touch
Panel.
*It is strongly recommended to touch softly the Touch Panel
ZLWKWKHDWWDFKHGVW\OXVSHQRUZLWK\RXU¿QJHUWLSV1HYHU
use your finger pad to push the Touch Panel. Using your
¿QJHUSDGZRXOGUHVXOWLQSXVKLQJDZLGHDUHDRIWKH7RXFK
Panel, which may cause the difficulty of identifying your
desired button because you might be touching more than one
button at a time. As a result, this may mislead you to push
the Touch Panel much harder and destroy the glass sheet.
*Plastic film is attached on the glass of the touch panel.
Please be careful so that you don't scratch the touch panel
with something hard, such as metal and sand sticking on the
surface. And don't push the touch panel too hard and don't
give any physical shock to the surface.
$OWKRXJK\RXPD\¿QGVRPHDLUEXEEOHVXQGHUWKHSODVWLF
panel due to environmental changes such as temperature, it
is not a defect.
Rotary key
In addition to touch panel, you can select items
by rotating the rotary keys to the left or to the right.
Direct key
<RXFDQGLUHFWO\FDOO\RXUIDYRULWHIXQFWLRQVRU
menu screens.
(The default setting at the factory)
S1: System menu
S2: Linkage menu
S3: Model menu
S4: Return
[How to change assignment of the direct key]
1. Open the screen you want to call. Then push
S1 and S4 keys simultaneously. (You will see
the direct key setting screen.)
2. Select the direct key.
Stick Adjustment
Adjustment of the stick lever angle
<RXFDQPDNHILQHDGMXVWPHQWVWRWKHDQJOHRI
a stick lever either inwards or outwards from the
center stick position.
Ɣ6FUHZ
Use the attached 1.5mm hexagonal wrench
LQVLGHVW\OXV WRWXUQWKHVFUHZFORFNZLVHWRDGMXVW
the stick outwards, or counter-clockwise to tilt it
inward.
Note: The screw will fall out if you turn the screw counter-
clockwise too far.