Futaba FX-40 - Manual (Page 63)

63 <Linkage Menu>
ŏ5HWXUQWR/LQNDJH0HQX
ŏ7RXFKWKH>6HUYR5HYHUVH@EXWWRQLQWKH/LQNDJH
0HQXWRFDOOWKHVHWXSVFUHHQVKRZQEHORZ
Servo Reverse
8VHWRUHYHUVHWKHWKURZGLUHFWLRQ
(The display screen is an example. The screen depends on the model type.)
Servo Reverse changes the direction of an
individual servo’s response to a control stick
movement.
For CCPM helicopters, be sure to read the
section on Swash AFR before reversing any servos.
With CCPM helicopters, always complete your
servo reversing prior to any other programming.
If you use pre-built Airplane/Sailplane functions
Servo reversing procedure
After setting up a new model, be sure to
define all special menus. Be sure that all servos
are plugged into the proper receiver channels.
Now, determine whether you need to reverse any
channels by moving each stick and observing the
corresponding movement in the model’s controls.
 7RXFK WKH GHVLUHG FKDQQHO·V 6HWWLQJ EXWWRQ
WRFKRRVHWKHSURSHUGLUHFWLRQIRUWKHVHUYR
7RXFK´ <HVµLQWKHQH[WVFUHHQ
5HSHDWIRUHDFKVHUYRQHHGLQJUHYHUVDO
:KHQGRQHWRXFK´ 6HUYR5HYHUVHµWRUHWXUQWR
WKH/LQNDJH0HQX
that control multiple servos, it may be confusing
to tell whether the servo needs to be reversed or a
setting in the function needs to be reversed. See the
instructions for each specialized function for further
details. Always check servo direction prior to every
ÀLJKWDVDQDGGLWLRQDOSUHFDXWLRQWRFRQ¿UPSURSHU
model memory, hook ups, and radio function.