Futaba FX-40 - Manual (Page 98)

98 <Model Menu (Airplane/Glider Functions)>
$LUEUDNH >&RUUHVSRQGLQJPRGHOW\SH@ $LUSODQHJHQHUDO
This function is used when an air brake is
necessary when landing or diving, etc.
The preset elevators and flaps (camber flap,
brake flap) offset amount can be activated by a
switch.
The offset amount of the aileron, elevator, and
flap servos can be adjusted as needed. Also the
VSHHGRIWKHDLOHURQHOHYDWRUDQGÀDSVHUYRVFDQ
be adjusted. (IN side/OUT side) A delay can be set
for each condition, and a Cut switch which will
turn OFF the delay can be chosen. Trim amounts
FDQEHILQHWXQHGE\VHWWLQJD95<RXFDQDOVR
set the Auto Mode, which will link Airbrake to a
stick, switch, or dial. A separate stick switch or
dial can also be set as the ON/OFF switch.
ŏ5HWXUQWR0RGHO0HQX
ŏ:KHQDÀQHWXQLQJ95LVVHWRQWKHQH[WVFUHHQ  WKHDLOHURQ
DQGÁDSWULPUDWHVFDQEHDGMXVWHG7RXFKWKHFRUUHVSRQGLQJ
button and adjust the rates with the adjustment buttons
displayed on the screen.
ŏ7KHDLOHURQÁDSDQGHOHYDWRURIIVHW
rates can be adjusted.
Touch the corresponding button
a n d a d j u s t t h e r a t e w i t h t h e
adjustment buttons displayed on
the screen.
ŏ 7RXFK WKH >$LUEUDNH@ EXWWRQ LQ WKH 0RGHO 0HQX WR
call the setup screen shown below. (The display
screen is an example. The actual screen depends
on the model type. The screen shown below is for 4
DLOHURQVDQGÁDSV
(Touch the [1/2] button to switch to page 2.)
ŏ 7RXFK WKH $&7 EXWWRQ DQG VHW WKH IXQFWLRQ WR
$&7 21 
ŏ :KHQ VHWWLQJ D VZLWFK WRXFK WKH 6ZLWFK EXWWRQ
to call the <Switch> screen, and then select the
VZLWFKDQGVHWLWV21GLUHFWLRQ $OZD\V21DW18//
setting)
(For a description of the switch selection method, see the description at
the back of this manual.)
6HWWLQJH[DPSOHIRU)$DQGRWKHUÀDSHURQ
VSHFL¿FDWLRQV
:KHQDLOHURQVPRGHOW\SHVHOHFWHG
(Page 1/2)
2IIVHWUDWH
$,/ >a@$,/ >a@(/( >_@
1RWH 7KHLQSXWQXPHULFVDUHH[DPSOHV$GMXVWWKHWUDYHOWR
match the fuselage.
(Screen 2/2)
$&7 >21@
Group: [Sngl]
6ZLWFK >6&&@
0RGH >0DQXDO@