Futaba FX-40 - Manual (Page 21)

21 <Before Use>
RF module FX-FM
To change the frequency band, use the FX-FM
module which is sold separately.
ƔRF module
Ɣ&RQQHFWRU
CAUTION
Turn off the power to the transmitter before you
remove or install the module.
Removing the RF module
1. Turn off the power to the transmitter.
2. Open the rear cover. (See [Precautions when
opening the rear cover and working inside].)
3. Grip the tabs at the left and right sides of the
module and pull the module straight out.
*There are two connectors; one at the top and one at the
bottom. If the module is not pulled out straight, it will be
GLI¿FXOWWRUHPRYH
Installing the RF module
1. Insert the module until it bottoms while being
careful not to bend the pins of the transmitter
side connector.
Toolbox
Ɣ7RROIRUUHPRYLQJ
RUQDPHQWDOQXWV
Ɣ+H[:UHQFK
PPDQGPP
Ɣ5XEEHU&DS
<RXFDQXVHWKHWRROER[FRQWDLQHGLQWKHVHWIRU
YDULRXVDGMXVWPHQWRIWKHWUDQVPLWWHU
Hexagonal wrench (1.5mm and 2.5mm)
7KHVH ZUHQFKHV DUH IRU DGMXVWPHQW RI VWLFNV
UHSODFHPHQWRIWKHVZLWFKHVDQGDGMXVWPHQWRIWKH
antenna.
Tool for removing ornamental nuts
This is for replacement of switches.
Stylus pen
5XEEHUFDSLVDWWDFKHGRQWKHWLSRIWKHWRRO<RX
may use this tool as a stylus pen for operating the
touch panel. This stylus pen can let you do more
precise operation than fingers without damaging
the surface.
Ɣ<RXPD\XVHWKLVWRRO
DVDVW\OXVSHQ