Futaba FX-40 - Manual (Page 65)

65 <Linkage Menu>
ŏ5HWXUQWR/LQNDJH0HQX
ŏ7RXFKWKH>(QG3RLQW $79 @EXWWRQLQWKH/LQNDJH
0HQXWRFDOOWKHVHWXSVFUHHQVKRZQEHORZ
End Point (ATV)
6HWVWKHWUDYHOOLPLWSRLQWDQGVSHHGRIHDFKVHUYR
(The display screen is an example. The screen depends on the model type.)
The End Point function adjusts the left and right
servo throws, generates differential throws, and
will correct improper linkage settings.
The Travel rate can be varied from 30% to 140%
in each direction on channels 1 to 12. Also, the
Limit point where servo throw stops may be varied
from 0% to 155%.
Servo travel adjustment
7RXFKWKH7UDYHOEXWWRQRIWKHFKDQQHO\RX
ZDQW WR VHW $GMXVWPHQW EXWWRQV DSSHDU RQ
WKHVFUHHQ
8VHWKHVHEXWWRQVWRDGMXVWWKHUDWH
ŏ,QLWLDOYDOXH 
ŏ$GMXVWPHQWUDQJH a
5HSHDWWKHSURFHGXUHDERYHIRUHDFKUDWH
Limit point adjustment
 7RXFK WKH /LPLW EXWWRQ RI WKH FKDQQHO \RX
ZDQWWRVHW
8VHWKHDGMXVWPHQWEXWWRQVWRDGMXVWWKHOLPLW
SRLQW
ŏ,QLWLDOYDOXH 
ŏ$GMXVWPHQWUDQJH a
5HSHDWWKLVSURFHGXUHIRUHDFKOLPLWSRLQW
NOTE: The indicators on the screen display actual servo
throw of the each channel. The center position of the
indicator is based on the Sub-Trim settings. Therefore the
Sub-Trim adjustment changes the Limit point display of the
indicator. The Servo Speed setting is used to set the servo
delay for each channel, from channel l to channel 12. The
system uses the programmed speed (delay) to slow down
servo position changes. The Servo Speed setting can be
varied from 0 to 20 in each channel.
Servo speed setting
7RXFKWKH6SHHGEXWWRQRIWKHFKDQQHO\RX
ZDQWWRVHW
 8VH WKH DGMXVWPHQW EXWWRQV WR DGMXVW WKH
VHUYRVSHHG
ŏ,QLWLDOYDOXH 
ŏ$GMXVWPHQWUDQJH a VWHSV
5HSHDWWKLVSURFHGXUHIRUHDFKFKDQQHO
7R FORVH WKLV VFUHHQ WRXFK WKH >(QG 3RLQW
$79 @EXWWRQ