Futaba FX-40 - Manual (Page 124)

124 <Data>
Curve setting operation
This section describes the setting procedure of curves which are used with the AFR function and each
mixing function.
Curve type selection
When the curve type select button on the mixing function screen or other screen is touched, the setup
screen shown below is called.
ŏ5HWXUQWRRULJLQDOVHWXSVFUHHQ
of original function
Curve type selection
1. Touch the button of the curve type you want to use.
*The curve type changes and the display returns to the original screen.
Linear curve adjustment
Rate A and Rate B can be adjusted separately or
simultaneously.
>6HWWLQJPRGHV@
* [ S e p a r a t e ] m o d e : 5DWHV DUH DGMXVWHG
separately.
*[Combined] mode:  5DWHV DUH DGMXVWHG
simultaneously.
>6HWWLQJPHWKRG@
1. Select the setting mode.
7RXFKWKH5DWH$RU5DWH%EXWWRQ
8VHWKHDGMXVWPHQWEXWWRQVWRVHWWKHUDWH
*Initial value: +100.0%

$GMXVWPHQWUDQJH a
The curve can also be offset horizontally in the
vertical direction and the rate reference point can
be offset to the left or right.
>2IIVHWWLQJWKHFXUYHKRUL]RQWDOO\LQWKHYHUWLFDO
GLUHFWLRQ@
7RXFKWKH2IIVHWEXWWRQ
 8VH WKH DGMXVWPHQW EXWWRQV WR PRYH WKH
FXUYHKRUL]RQWDOO\XSDQGGRZQ
*Initial value: +0.0%
Setting by curve type
When the curve type is selected as described above, adjustment buttons corresponding to the curve type
appear on the original screen. Adjust each curve as described below.
>2IIVHWWLQJ WKH UDWH UHIHUHQFH
SRLQWWRWKHOHIWRUULJKW@
7RXFKWKH;2IIVHWEXWWRQ
 8VH WKH DGMXVWPHQW EXWWRQV WR
move the reference point to the
left or right.
*Initial value: +0.0%
(Linear curve)
5DWHDGMXVWPHQWEXWWRQV
ŏ5HWXUQWRLQLWLDOYDOXH