Futaba FX-40 - Manual (Page 81)

81 <Model Menu (Airplane/Glider Functions)>
MODEL MENU (AIRPLANE/GLIDER FUNCTIONS)
These functions usable when airplane, glider,
or EP glider model type is selected are displayed
in this Model Menu functions section. First use
the Model Type function of the Linkage Menu
to preset the model type, wing type, and tail type
matched to the fuselage used. Later setting resets
the data set by mixing function, etc.
These functions can be set for each flight
condition, as required. When you want to use
the system by switching the settings for each
condition by switch or stick position, use the
&RQGLWLRQ6HOHFWIXQFWLRQWRDGGÀLJKWFRQGLWLRQV
(Up to 8 conditions can be used)
Note: The FX-40 is designed so that the airplane and
glider (including EP glider) model types can handle
aircrafts of the same wing type.
The functions common to airplanes and gliders,
except some functions, summarized without regard
to the model type.
The setting items are different, depending on the
number of servos, etc. according to the wing type
used. However, reread them. The setup screens in
the instruction manual are typical examples.
ŏ5HWXUQWR+RPHVFUHHQ
ŏ 7RXFK WKH 0RGHO 0HQX EXWWRQ RI WKH +RPH VFUHHQ WR
FDOOWKLV0RGHO0HQX
ŏ :KHQ WKH EXWWRQ RI WKH IXQFWLRQ \RX ZDQW WR VHW LV
touched, a setup screen appears.
(Model Menu screen example)
*The Model Menu screen depends on the model type. This screen is for model type 4AIL+4FLP.
ŏ7RQH[WSDJH
Model Menu functions list
Ɣ$,/'LIIHUHQWLDO
This function adjusts the left and right ailerons.
5ROOD[LVFRUUHFWLRQDQG¿QHWXQLQJZLWKD95DUH
also possible. This is convenient when making
VHWWLQJVGXULQJÀLJKW
[Airplane/glider, 2 ailerons or more]
Ɣ)ODS6HWWLQJ
7KHÀDSVFDQEHDGMXVWHGLQGHSHQGHQWO\)RUD
ÀDSVPRGHOWKHFDPEHUÀDSVFDQEHPL[HGZLWK
WKHEUDNHÀDSV>$LUSODQHJOLGHUÀDSVRUPRUH@
Ɣ$,/WR&DPEHU)/3
This mixing operates the camber flaps in
the aileron mode. It improves the operation
characteristic of the roll axis. [Airplane/glider, 2
DLOHURQVÀDSVRUPRUH@
Ɣ$,/WR%UDNH)/3
This mixing operates the brake flaps in
the aileron mode. It improves the operation
characteristic of the roll axis. [Airplane/glider, 4
ÀDSVRUPRUH@
Ɣ$,/WR58'
This mixing is used when you want to operate
the rudder with aileron operation. Banking at a
shallow bank angle is possible. [Airplane/glider, 2
DLOHURQVÀDSVRUPRUH@
Ɣ$LUEUDNHWR(/(
This mixing is used to correct operation of
the airbrakes (spoilers) when landing. [Airplane/
glider, general]
Ɣ58'WR$,/
This mixing is used to correct roll maneuvers,
knife edge, etc. of stunt planes. [Airplane/glider,
general]