Futaba FX-40 - Manual (Page 15)

15 <Before Use>
[Replacement]
1. Turn off the power to the transmitter and
then use the switch ornamental nut jig
LQ WKH DFFHVVRU\ WRRO ER[ WR UHPRYH WKH
ornamental nut.
Ɣ2UQDPHQWDOQXW
Ɣ'XVWSURWHFWLRQFDS
7KHVZLWFKFDQEH
LQVWDOOHGLQWKHWRSRU
ERWWRPPRXQWLQJKROH
2. Open the rear cover, and remove the
battery.
(See [Precautions when opening the rear cover
and working inside].)
3. Disconnect the connector of the switch you
want to replace.
*The photo below is a view with switch A(SA) removed.
Ɣ&RQQHFWRU
Ɣ6ZLWFK Ɣ2UQDPHQWDOQXW
4. Use the ornamental nut to install the switch
r e m o v e d f r o m a n o t h e r p o s i t i o n , o r a n
optional switch, to the switch mounting hole
by the reverse procedure of the above.
5. Connect the connector.
[Connector wiring color]
Ɣ6$DQG6& *UHHQ
Ɣ6%DQG6' <HOORZ
Ɣ6(DQG6* 2UDQJH
Ɣ6)DQG6+ %URZQ
&RQQHFWRU
%ODFN 5HG
7KHFRORUYDULHVGHSHQGLQJRQWKHVZLWFK
6. Install the battery and then close the rear
cover.
(See the preceding item.)
7. Change the setting at the [Important] System
menu switch setting window to match the
type of the new switch.
Volume
Locked state
Volume LD, CD, and RD:
If you push the volume (LD or RD) to the
bottom, the volume will stay there. If you push the
volume again, the lock will be released and become
operative again.
This volume (CD) is digital type (rotary
encoder). This volume works as both a volume and
a push-switch.
*FX-40 beeps when the volume knob reaches center.
<RX FDQ FKHFN WKH YROXPH SRVLWLRQ RQ WKH 'LDO 0RQLWRU
screen in the Linkage menu.
<RXFDQXVHHDFKVHWWLQJVFUHHQRIWKHPL[LQJIXQFWLRQVWR
VHOHFWYROXPHVDQGGH¿QHWKHGLUHFWLRQRILWVPRYHPHQW
Slide Lever
L1 (right side), L2 (center), L3 (left side):
A click will be felt at the center of slide lever
operation.
*It sounds when the lever comes to the center.
<RXFDQFKHFNWKHOHYHUSRVLWLRQRQWKHGLDOPRQLWRUVFUHHQ
in the linkage menu.
<RXFDQVHOHFWDVOLGHOHYHUDQGVHWWKHPRYHPHQWGLUHFWLRQ
on the setting screen of mixing functions.