Futaba FX-40 - Manual (Page 37)

37 <System Menu>
Operation direction reversal method
 7RXFK WKH VHWWLQJ EXWWRQ FRUUHVSRQGLQJ WR
WKH+: +DUGZDUH \RXZDQWWRUHYHUVH
 5HYHUVH WKH +: E\ WRXFKLQJ ><HV@ :KHQ
\RX ZDQW WR VWRS RSHUDWLRQ WRXFK >1R@
> 1 R U P D O @  1 R U P D O  R S H U D W L R Q  G L U H F W L R Q
>5HYHUVH@ 5HYHUVHVWKHRSHUDWLRQGLUHFWLRQ
H/W Setting
6WLFNVZLWFKWULPOHYHUDQGNQRERSHUDWLRQGLUHFWLRQUHYHUVDO +DUGZDUH
UHYHUVH 6WLFNUHVSRQVHDQGKLVWHULVLVDGMXVWPHQW 6WLFN6HWWLQJ
H/W Reverse
This function reverses the operation signal of the
sticks, switches, trimmer levers, and knobs.
Note: This setting reverses the actual operation
signal, but does not change the display of
the indicators on the display. Use the Normal
mode as long as there is no special reason to
use the Reverse mode.
Stick Setting
This function sets the servo response and
hysteresis for stick operation for each condition.
The control feeling of the stick can be adjusted to
match the aerobatics.
ŏ 7RXFK WKH >+: 6HWWLQJ@ EXWWRQ DW WKH 6\VWHP
0HQXWRFDOOWKHVHWXSVFUHHQVKRZQEHORZ
ŏ5HWXUQWR6\VWHP0HQX
Stick mode
The stick mode of the FX40 is set to mode 1 or 2
(factory setting). It can be changed to mode 2 or 1.
Note: It may be necessary to change the stick
mode before setting the model data. The
mode of an already set model and the mode
of the currently used model are not changed.
The model mode is applied to models added
after the model mode change, or to models
whose operation data has all been reset by
data reset function.
Note: Set the throttle stick ratchet mechanism
by referring to [Stick adjustment].
ŏ 7RXFK WKH >+: 5HYHUVH@ EXWWRQ DW WKH +:
6HWWLQJ 0HQX WR FDOO WKH VHWXS VFUHHQ VKRZQ
EHORZ
ŏ5HWXUQWR+:6HWWLQJ0HQX