Futaba FX-40 - Manual (Page 51)

51 <Linkage Menu>
FUNCTIONS OF LINKAGE MENU
The Linkage Menu is made up of functions
which perform model addition, model type
selection, frequency setting, end point setting, and
other basic settings.
ŏ5HWXUQWR+RPHVFUHHQ
ŏ:KHQDEXWWRQLQWKH/LQNDJH0HQXRIWKH+RPHVFUHHQ
LV WRXFKHG WKH PHQX VKRZQ EHORZ LV FDOOHG 7RXFK WKH
EXWWRQRIWKHIXQFWLRQ\RXZDQWWRVHW
The functions which can be selected depend on
the model type. A typical menu screen is shown
below.
(The display screen is an example. The screen depends on the model type.)
Linkage Menu functions table
[Servo Monitor]: Displays the servo test and operation position
[Model Select]: Model addition, call, deletion, copy, model name setting
[Model Type]: Model type, wing type, tail type
[Picture]: Picture selection for each model
[Sound]: Sound recording and playback
[Frequency]: Frequency selection, modulation mode selection, receiver ID setting
[Function]: Channel assignment of each function can be changed
[Sub-Trim]: Adjusts the neutral position of each servo
[Servo Reverse]: Servo direction reversal
[Fail Safe]: Fail safe function and battery fail safe function setting
[End Point (ATV)]: Servo basic rudder adjustment and limit setting
[Throttle Cut]: Stops the engine safely and easily (airplane and helicopter only)
[Idle Down]: Lowers the idle speed of the engine (airplane and helicopter only)
[Swash]: Swash AFR and linkage correction function (helicopter only)
[Timer]: Timer setting and lap time display
[Dial Monitor]: Dial, sliding lever, and digital trim position display
[Data Reset]: Model memory set data reset (by item)