Futaba FX-40 - Manual (Page 127)

127 <Data>
Switch selection method
The various functions used in the FX-40 can be selected by switch. The switch (including when stick,
trim lever, or VR are used as a switch) setting method is common to all functions.
Switch selection
When the switch select button at a mixing function screen or other screen is touched, the selection shown
below is called.
(Switch selection screen example)
When switch is selected
Switch ON/OFF setting is possible at each
position.
ŏAlternate: $OWHUQDWH VZLWFKLQJ PRGH LV
available depending on mixing function.
:KHQWKH21SRVLWLRQVZLWFKLVWRXFKHGDIWHU
the switch was selected, the screen shown
below appears.
*When the button of each position is touched,
LWWRJJOHVEHWZHHQ21DQG2))
7RXFKWKHEXWWRQDQGVHWWRWKH21SRVLWLRQ
&ORVHWKHVFUHHQE\WRXFKLQJ>&ORVH@
When stick, trim lever, or VR is selected.
When a stick, trim lever, or VR is used as a
switch, the following 4 modes can be selected.
ŏMode: Lin/Sym
ŏType:+\VWHUHVLV +\V ER[ %R[
:KHQWKH21SRVLWLRQEXWWRQLVWRXFKHGDIWHU
stick, etc. was selected, the screen shown
below appears.
2. Select the mode you want to use, and set it
as described below.
&ORVHWKHVFUHHQE\WRXFKLQJ>&ORVH@