Interlogix Simon XT Installation Manual - Manual (Page 58)

52 Simon XT Installation Manual
3. Enter your access code and press Enter. The panel displays Access codes.
4. Press the scroll buttons until the panel displays Light control.
5. Press Enter. The panel displays Set entry lights.
6. Press Enter. The panel displays Entry light unit 1 on/off.
7. Press the scroll buttons until the unit number you want to program displays.
8. Press Enter. The panel displays Off, which will be flashing.
9. Press the scroll buttons until the panel displays On, then press Enter.
10. Press STATUS three times to exit program mode.
To program a sensor-activated light:
1. Press the scroll buttons until the panel displays System programming.
2. Press Enter. The panel displays Enter code.
3. Enter your access code and press Enter. The panel displays Access codes.
4. Press the scroll buttons until the panel displays Light control.
5. Press Enter. The panel displays Set entry lights.
6. Press the scroll buttons until the panel displays Sensor light.
7. Press Enter. The panel displays Sn ## <Text> X-10 unit = on/off.
8. Press the scroll buttons until the panel displays the sensor number you want
to activate.
9. Press Enter. The panel displays On/off, which will be flashing.
10. Press the scroll buttons until the panel displays On.
11. Press Enter.
12. Press STATUS three times to exit.
Note: You can also program a keyfob button to control a light or appliance
module.
To program a light schedule:
Press the scroll buttons until the panel displays System programming.
1. Press Enter. The panel displays Enter code.
2. Enter your access code and press Enter. The panel displays Access codes.
3. Press the scroll buttons until the panel displays Light control.
4. Press Enter. The panel displays Set entry lights.
5. Press the scroll buttons until the panel displays Set entry lights.
6. Press Enter.