Interlogix Simon XT Installation Manual User Manual
Page 6
The plug and jack used to connect this equipment to the premises wiring and
telephone network comply with the applicable FCC Part 68 rules and requirements
adopted by ACTA. A compliant telephone cord and modular plug is provided with this
product. It is designed to be connected to a compatible modular jack that is also
compliant. See the installation instructions for details.
The REN is used to determine the maximum number of devices that may be
connected to your telephone line. Excessive RENs on a telephone line may result in
devices not ringing in response to an incoming call.
In most cases, the sum of all device RENs should not exceed five (5.0). To be certain
of the number of devices that may be connected to a line, as determined by the total
RENs, contact your local telephone company.
For products approved after July 23, 2001, the REN is part of the identifier with the
format
US:AAAEQ##TXXXX
. The digits represented by
##
are the REN without a decimal
point. (For example, 03 is a REN of 0.3). For earlier products, the REN is separately
shown on the label.
Alarm dialing equipment must be able to seize the telephone line and place a call in
an emergency situation. It must be able to do this even if other equipment
(telephone, answering system, computer modem, etc.) already has the telephone line
in use. To do so, alarm dialing equipment must be connected to a properly installed
RJ31X jack that is electrically in series and ahead of all other equipment attached to
the same telephone line. If you have any questions concerning these instructions,
consult your local telephone company or a qualified installer about installing an
RJ31X jack and alarm dialing equipment for you.
If this equipment causes harm to the telephone network, the telephone company may
temporarily disconnect your service. The telephone company may notify you in
advance, but when advance notice isn’t practical, they will notify you as soon as
possible and advise you of your right to file a complaint with the FCC.
The telephone company may make changes in their facilities, equipment, operations,
or procedures that could affect the operation of the equipment. If they do, they will
notify you in advance so you can make the modifications to maintain uninterrupted
service.
This equipment may not be used on coin service provided by the telephone
company. Connection to party line service is subject to state tariffs. Contact the state
public utility commission, public service commission, or corporation commission for
information.
If you experience trouble with this equipment, please contact the company that
installed the equipment for service and repair information. If the equipment is causing
harm to the telephone network, the telephone company may ask you to disconnect
the equipment until the problem is resolved.
Contact information
o
Customer support