Interlogix Simon XT Installation Manual - Manual (Page 62)

56 Simon XT Installation Manual
Testing
This section describes how to perform various test procedures. You should test
the system after installing, after servicing, and after adding or removing devices
from the system.
Control panel
Test the panel by pressing the buttons as described in Table 26 below. Table 27
below provides a list of the arming levels.
Note: An access code is required when arming if the secure arming option is on.
Table 26: Control panel test sequence
Button Function tested Test Correct result
Doors+Windows The panel arms door
and window sensors. Press Doors+Windows a
second time to eliminate the
programmed entry delay. The button will blink
when the no entry
delay option is on.
Motions The panel will arm
motion sensors. Press Motions a second
time to turn the latchkey
option on. The button blinks when
latchkey is on.
Disarm The panel will prompt
you to enter an access
code. Enter the appropriate code. The panel will disarm
doors, windows, and
motion sensors.
Status Press Status for panel to
display and speak the
system status.
Police Press and hold or press the
button twice quickly to
activate a nonmedical
police, fire, or auxiliary
emergency alarm.
Fire
Emergency
Note: Forty key presses for invalid codes (ten invalid 4-digit codes, for example)
will cause a system access alarm. The alarm locks all touchpads, except key
fobs, for 90 seconds.
Table 27: Arming levels
Arming
level Description Indication
0 Subdisarms (master access and
duress codes only), and bypasses
24-hour intrusion sensors (master
access code only). Fire sensors
(group 26) cannot be
subdisarmed. One beep indicates the system is subdisarmed.
The pan
el displays and speaks “Subdisarmed”.
The Disarm button blinks.