Interlogix Simon XT Installation Manual - Manual (Page 59)

Simon XT Installation Manual 53
7. Press the scroll buttons until the panel displays Light schedules.
8. Press Enter. The panel displays Light schedule 1 <--:-- - --:-->.
9. Press the scroll buttons until the panel displays the unit number you want to
program.
10. Press Enter. The HH of the start time will flash.
11. Press the scroll buttons to set the hours.
12. Press Enter. The MM of the start time will flash.
13. Press the scroll buttons to set the minutes.
14. Press Enter. The AM/PM of the start time will flash.
15. Press the scroll buttons to set the AM/PM setting.
16. Press Enter. The end time starts to flash.
17. Follow the same instructions to set the hour, minute, and AM/PM settings for
the end time.
18. Press STATUS repeatedly to exit.
Lock interval
Note: This feature has not been investigated for use by UL.
Sets the start and stop times that determine when the panel prevents the sensor-
activated lights feature from turning on sensor-activated lights.
Note: System time must be set correctly for this feature to work.
When a time value is set (on) and the sensor-activated lights feature is on, the
panel prevents sensor-activated lights from turning on between the programmed
start time (this option) and the programmed stop time.
Both sensor-activated light lockout start time and sensor-activated light lockout
stop time must have a time programmed for this feature to work correctly.
When both sensor-activated light lockout start time and sensor-activated light
lockout stop time are turned off and the sensor-activated lights feature is on,
sensor-activated lights turn on at all times.
Table 24: Light control
Function Default Description
Set entry lights: Entry light
unit,
1 through 8
Off This menu allows the user to set X-10 lights with
unit numbers from 1 to 8 as entry lights (On).
Sensor light # 01 to 40 In this menu, each enrolled sensor can be
associated with an X-10 light with unit number
from 1 to 8 (or Off for no association).