Interlogix Simon XT Tabletop Installation Manual - Manual (Page 34)

Chapter 3:
28 Simon XT TableTop Control Panel Installation Manual
Applying AC power
To apply AC power, do the following:
1. Make sure the outlet is not controlled by a switch or that it is not part of a
ground fault circuit interrupt (GFCI).
2. Remove the center screw from the outlet cover plate and hold the cover plate
in place.
WARNING: Use extreme caution when securing the transformer to a metal outlet
cover. You could receive a serious shock if a metal cover drops down onto the
prongs of the plug.
3. Plug the transformer into the lower receptacle of the outlet so that the hole in
the transformer tab lines up with the outlet cover screw hole.
4. Insert the cover plate screw through the transformer tab and the outlet cover
plate. Tighten the screw.
X10 modules
To install lamp and appliance modules, do the following:
1. Set the unit code dial to a unit number between 1 and 8.
2. Set the housecode for the installation.
3. Plug the module into a wall outlet.
4. Plug the lamp/appliance into the module
Caution: Do not plug in appliances or lamps with 300-watt or larger bulbs into
Lamp modules.
To install universal modules, do the following:
1. Set the unit code dial to a unit number different from all other X10 modules
(between 1 and 8).
2. Set the housecode for the installation.
3. Set the module switches to momentary and relay only.
4. Connect the module terminals to the desired device terminals.
5. Plug the universal module into a wall outlet.
To install powerhorn modules, do the following:
1. Set the unit code dial to unit number 9 or 10.