Interlogix Simon XT Tabletop Installation Manual - Manual (Page 46)

Chapter 4:
40 Simon XT TableTop Control Panel Installation Manual
Function Default Description
Autoarm On Determines how long the system protests (announces open/failed
sensors) when attempting to arm with open/failed sensors , before
bypassing these sensors and automatically arming the rest of the
system.
The panel protests an arming attempt when it has not received a
restore (close) signal from sensors learned into restore-specific
sensors groups. Sensors learned into group 26 (fire) cannot be
bypassed.
When this option is on, the panel announces all open/failed
sensors repeatedly for 4 minutes, then automatically bypasses the
open sensors and arms the rest of the system. If a sensor is
opened during the exit delay and then left open, the panel will go
into alarm after the exit delay has expired.
This option must be on for Unvacated premises and Exit
extension to work correctly.
When this option is off, the panel displays all open/failed sensors
once, then automatically bypasses the open sensors and arms
the rest of the system after the exit delay has expired. If other
sensors are opened during the exit delay, they will also be
bypassed if left open.
Note: If group 13 (instant perimeter) sensors are opened during
the exit delay, the panel goes into immediate alarm.
Exit extend On Determines whether the panel restarts the exit delay time if the
user enters the armed premises during the initial exit delay period
(on), or not (off). Turning on this feature allows users to reenter
during the exit delay period, without disarming and then rearming
the system. Turning off this feature requires the user to disarm
and rearm the system.
Autoarm must be on for this option to work.
Secure arming Off Determines whether an access code is required when arming the
system (on) or not (off). This option does not affect keyfob
arm/disarm operation.
No arm on low
battery Off Determines whether the system protests arming if a low CPU
battery condition exists (on) or not (off).
Quick exit Off Determines whether pressing Disarm when the system is armed
activates the exit delay time to allow exit and reentry without
disarming the system (on) or not (off).
This feature is useful if the user wants to step outside briefly and
return, such as to get the paper. If the system is armed and the
user presses Disarm, the panel announces Exit time is on and
sounds exit delay beeps. This allows a designated entry/exit door
to be open for up to 2 minutes without causing alarm. When the
door is closed, the beeps stop and the door is armed again.
Downloader
enable On Enables programming of system options with downloader
software.