Interlogix Simon XT Tabletop Installation Manual - Manual (Page 61)

Chapter 4:
Simon XT TableTop Control Panel Installation Manual 55
6. The panel displays On/off, which will be flashing. Press the scroll buttons until
the panel displays On. Press Enter.
7. Press Status three times to exit.
Note: You can also program a keyfob button to control a light or appliance
module.
To program a light schedule, do the following:
1. Press the scroll buttons until the panel displays System programming. Press
Enter.
2. The panel displays Enter code. Enter your access code and press Enter.
3. The panel displays Access codes. Press the scroll buttons until the panel
displays Light control. Press Enter.
4. The panel displays Set entry lights. Press the scroll buttons until the panel
displays Set entry lights. Press Enter.
5. Press the scroll buttons until the panel displays Light schedules. Press Enter.
6. The panel displays Light schedule 1 <--:-- - --:-->. Press the scroll buttons
until the panel displays the unit number you want to program. Press Enter.
7. The HH of the start time will flash. Press the scroll buttons to set the hours
and press Enter.
8. The MM of the start time will flash. Press the scroll buttons to set the minutes
and press Enter.
9. The AM/PM of the start time will flash. Press the scroll buttons to set the
AM/PM setting and press Enter.
10. The end time starts to flash. Follow the same instructions to set the hour,
minute, and AM/PM settings for the end time.
11. Press Status repeatedly to exit.
Lock interval
Sets the start and stop times that determine when the panel prevents the sensor-
activated lights feature from turning on sensor-activated lights. When a time
value is set (on) and the sensor-activated lights feature is on, the panel prevents
sensor-activated lights from turning on between the programmed start time (this
option) and the programmed stop time. When both sensor-activated light lockout
start time and sensor-activated light lockout stop time are turned off and the
sensor-activated lights feature is on, sensor-activated lights turn on at all times.
Note: System time must be set correctly for this feature to work. Both sensor-
activated light lockout start time and sensor-activated light lockout stop time must
have a time programmed for this feature to work correctly.