KERN & SOHN KET-TM - Manual (Page 23)

KEN-TM / KET_TM-BA-e-1420 23
6 Unpacking, Setup and Commissioning
6.1 Installation Site, Location of Use
The display units are designed in a way that reliable weighing results are achieved in
common conditions of use.
Precise and fast work is achieved by selecting the right place for your display unit and
your weighing plate.
On the installation site observe the following:
• Place the weighing system on a firm, level surface;
• Avoid extreme heat as well as temperature fluctuation caused by installing next
to a radiator or in the direct sunlight;
• Protect the display unit and the weighing plate against direct draft from open
windows or doors.
• Avoid jarring during weighing;
• Protect the display unit and the weighing plate against high humidity, vapours
and dust.
• Do not expose the display unit to extreme dampness for longer periods of time.
Non-permitted condensation (condensation of air humidity on the appliance) may
occur if a cold appliance is taken to a considerably warmer environment. In this
case, acclimatize the disconnected appliance for ca. 2 hours at room
temperature.
• Avoid static charge of goods to be weighed or weighing container.
Major display deviations (incorrect weighing results) may be experienced should
electromagnetic fields (e.g. due to mobile phones or radio equipment), static electricity
accumulations or instable power supply occur. Change location or remove source of
interference.
6.2 Unpacking and placing
Take the display unit carefully out of its packaging, remove the plastic jacket and install
it at the designated work space. Mount the display unit in a way that facilitates operation
and where it is easy to see.
The display unit is not mounted rigidly on the weighing platform. If
required, it may be placed independently within the vicinity of the weighing
scale as long as the length of the cable allows such a setup.
6.3 Scope of delivery / serial accessories
KET-TM KEN-TM
Display Unit Display unit with integrated power unit
Protective cover Operating and Installation Instructions
Mains adapter
IEC cable
Ferrite core for cable shielding
Operating and Installation Instructions