Cadence Telephony - Manual (Page 33)

23
Telephone Operations
Day Ringing/Night Ringing
Enable Day Ringing
Enable Night Ringing
The NexPath Telephony Server has two modes of operation that affect both the ringing of all extensions and
the auto-attendant: Day Mode (day ringing) and Night Mode (night ringing). Each extension can pro-
grammed to ring at different lines or groups of lines when the system is switched from Day Mode to Night
Mode. For example, an extension may be programmed so that calls placed to it ring one particular phone
when the system is in Day Mode, but ring all the phones in an entire ring group when the system is in Night
mode so that anyone left in the building can pick it up.
The auto-attendant may also have a Day Mode program and a Night Mode program. A different message
and set of choices may be presented to the caller depending on whether it is during regular business hours or
after hours. All of these features depend on the configuration and setup that is done by the system adminis-
trator when the system is installed or configured.
To enable day ringing (and disable night ringing):
1. Pick up any phone or otherwise get an inside line dial tone.
2. Enter the Enable Day Ringing sequence .
3. If prompted, enter your password
1
, or a password with administrator privileges.
4. If your password was accepted, you will be notified that day ringing has been enabled.
5. Hang up.
To enable night ringing (and disable day ringing):
1. Pick up any phone or otherwise get an inside line dial tone.
2. Enter the Disable Day Ringing sequence .
3. If prompted, enter your password 1 .
4. If your password was accepted, you will be notified that day ringing has been disabled.
1. You will not be asked for a password if you have already entered it once to enable some other command and you have not
hung up since then.
# 0
# 1
# 0
# 1
user.bk Page 23 Wednesday, March 7, 2001 10:34 AM