Carrier Access Access Bank II SNMP - Manual (Page 152)

Command Line Interface (CLI)
9/24/01 14-7
.
Figure 14-3: Local and Remote RS-232 CLI Management
Figure 14-4: Local and Remote Telnet CLI Management
14.4.2 RS-232 CLI Operation
To use the Command Line Interface (CLI) with an RS-232 connection to a VT-100 terminal:
1. Connect the RS-232 cable to RS-232 management port of the Access Bank II - SNMP. The
default settings are 9600,8,1,N.
2. From your PC, run a Microsoft Hyper Terminal ® session and press carriage return.
3. The Access Bank II - SNMP should display the following:
Access Bank
Boot Version 1.00
Management Version 1.29 08:38:48 12/22/1997
password:
4. Log into the management session by typing default password CAC
password:XXX
Password accepted.
Modem
Access
Bank II
SNMP
VT-100
Terminal
FXS
RS-232
T1
Modem
Telephone
Network
Remote
Control
VT-100
Terminal
Local
Control
Router
Access
Bank II
SNMP
Telnet
Terminal
Telnet in
data stream
V.35
Ethernet
10Base-T
T1
Remote
Control
Telnet
Terminal
Local
Control
Frame
or IP
Network
LAN