Carrier Access Access Bank II SNMP - Manual (Page 165)

14-20 9/24/01
There are no options for this command. To initiate a reboot, type boot and press return.
14.4.4.5 clk
Use the clk command to set the system clock sources. The Access Bank II - SNMP allows the user to
configure a primary and secondary clock source.
14.4.4.6 config
Use the config command to save/restore the connections configuration. The Access Bank II - SNMP
allows the user to save one configuration in addition to the factory defaults in battery backed RAM.
14.4.4.7 connections
Use the connections command to save or display the current connections between spans and groups.
This command allows the user to display all static connections and group definitions being utilized
by the system.
Operations Type Comments
To set primary clock
source to T1 #1 clk primary T1 1 This sets the primary system to clock
to be derived from T1 #1. For Access
Bank II - SNMP applications, this
should be the T1 that is being received
from the Long Distance carrier.
To set secondary clock
source to T1 #2 clk secondary T1 2
To display Help clk ?
Operations Type Comments
To restore factory
configuration config factory Resets all configurations to the factory
defaults.
To save current
configuration config save Saves current configuration to battery
backed RAM.
To display Help config ?