Carrier Access Access Bank II SNMP - Manual (Page 49)

5-2 9/24/01
5.2 Installing Cables and Adapters
After mounting the Access Bank II SNMP chassis and power converter, the next step is connecting
the various voice and data interfaces and the power connector using the standard and optional cables
and adapters listed below in Table 5-1. Table 5-1 shows where the various T1, V.35 and RS-232 inter-
face and power connector are located on the Access Bank II SNMP front Control Panel.
The Access Bank II SNMP shipping package contains one modular category 5 T1 network interface
cable, a 25-pin local management cable, a 25-pin to 25-pin null modem adapter, and a 25-pin to 9-pin
straight adapter. Additional optional category 5 T1 network interface cables can be ordered separately
from CAC. Optional V.35 data cables are also available from CAC.
Table 5-1: Standard and Optional Access Bank II SNMP Cables and Adapters
Part
Number Cable
Length Application Connectors
005-0009 10 foot,
3.05 m T1 Network Cable for connecting the
Access Bank II SNMP to the T1 network, or
optionally to a PBX D&I port. One of these
cables is included with each Access Bank II
SNMP purchase. Additional T1 Network
Cables must be ordered separately. RJ-48C to RJ-48C
005-0003-
DCE-MF-
10’ 10 foot,
3.05 m RS-232 Local Management Cable for man-
aging the Access Bank II SNMP using a
directly attached computer through the RS-
232 Management Port. This cable is
included with each Access Bank II SNMP
purchase. Fine Pitch D-Sub-26
Male to DCE DB-25
Female
005-0002-
25M-
25M-Null
Modem N/A RS-232 25-Pin Male to 25-Pin Male Null
Modem Adapter for connecting the Access
Bank II SNMP to an external modem
through either the included Local Manage-
ment Cable. This adapter is included with
each Access Bank II SNMP purchase. DCE DB-25 Male to
DTE DB-25 Male
005-0007-
25M-9F-
Straight N/A RS-232 25-Pin Male to 9-Pin Female
Straight Adapter for directly connecting the
Access Bank II SNMP to a 9-pin computer
device through either the included Local
Management Cable. This adapter is
included with each Access Bank II SNMP
purchase. DCE DB-25 Male to
DTE DB-9 Female
005-0008-
DCE-
MM-10’ 10 foot,
3.05 m Ten-foot V.35 Data Cable for connecting a
router or other digital device to a T1 net-
work using the Access Bank II SNMP’s
V.35 DCE data port, accommodating high-
speed transfers up to 1.536 Mbps. This cable
is optional and must be ordered separately. Fine Pitch D-Sub-26
Male to DCE V.35
Male