Carrier Access Access Bank II SNMP - Manual (Page 156)

Command Line Interface (CLI)
9/24/01 14-11
t11 ...............Set Clock Source to T1 #1
t12 ...............Set Clock Source to T1 #2
internal ..........Set Clock Source to internal
config ...............Set/Restore Configuration
code ipaddr “path” .Load app code “path” from TFTP server;
Specify the ipaddr and the path including
filename; System will reboot new code
download ...........(Diagnostic) Download current configura-
tion
factory ............Initialize and Download Factory Defaults
from [ipaddr “path”]Load configuration FROM XModem or TFTP
server; XModem is reliable for 19200 baud
or less; For the TFTP server, specify the
ipaddr and the path including filename
restore ............Restore/download last saved configuration
save ...............Save current configuration
to .................Send configuration TO XModem server
XModem is reliable for 19200 baud or less
connections ..........Display Connections
clear ..............Display Clear Channel Connections
dynamic ............Display Dynamic Connections
voice ..............Display Voice Channel Connections
craft ................Display/Set Craft Port
baud ...............Set Baud Rate
b1200 .............1200 baud
b2400 .............2400 baud
b4800 .............4800 baud
b9600 .............9600 baud
b19200 ............19200 baud
b38400 ............38400 baud
b57600 ............57600 baud
data ...............Set Data Size
bit7 ..............7 bit data
bit8 ..............8 bit data
dial “string” ......Set Modem Dialout String
hangup “string” ....Set Modem Hang Up String
init “string” ......Set Modem Initialization String
parity .............Set Parity
even ..............Even Parity
none ..............No Parity
odd ...............Odd Parity
stop ...............Set Stop Bits
bit1 ..............One Stop Bit
bit2 ..............Two Stop Bits
date .................Display/Set Date: date mm/dd/yyyy
dni ..................Display/Set DNI (DS1 to DS1) properties
signal .............Display DNI Signal Type
s:c [n] opt .......Set Signal Type for [n] channels from s:c