Carrier Access Access Bank II SNMP - Manual (Page 167)

14-22 9/24/01
14.4.4.10dni
Use the dni command to set the DNI properties for voice channels.
14.4.4.11dialout
Use the dialout command to set and display enabling for the dialout alarms.
14.4.4.12 ds1
Use the ds1 command to setup one or all the DS1 interfaces. The command specifies the interface
number (1-2) and the setting to apply. The ds1 command followed by the interface number will dis-
play the current configuration.
Operations Type Comments
To set signal type for n
channels from s:c
dni s:c [n] opt
To display signal type dni signal
To set DNI channel type dni type s:c [n] opt
To display DNI channel
type dni type
Operations Type Comments
To set all dialout alarms
enabled
dialout all on To see all dialout alarm enabling
options, type
dialout help
To display dialout alarm
enabling dialout
Operations Type Comments
To display the current
settings of ds1 1 ds1 1 Displays the current setting for T1 #1.
To display Help ds1 ?