Carrier Access Access Bank II SNMP - Manual (Page 154)

Command Line Interface (CLI)
9/24/01 14-9
commands, including all levels of options for each command. Typing help after a command name
provides a list of the command options at all levels.
1. Type ? at the prompt to list all of the commands, as shown below.
Commands ...............Command Line Interface Help. For immediate
context sensitive help, type ? at any time.
For full command help, type “help” after
any partial command.
\ .................Enter \ to go to the top command level
aco ...............Display/Set Alarm Cutoff
alarms .............Display/Set current alarms
aps ................Display/Set Automatic Protection Switching
boot ...............(Re)Boot the system... all connections
will be dropped during initialization
clk ................Display/Set T1 Clock
config .............Set/Restore Configuration
connections ........Display Connections
craft ..............Display/Set Craft Port
date ...............Display/Set Date: date mm/dd/yyyy
dni ................Display/Set DNI (DS1 to DS1) properties
dialout ............Display/Set dialout alarm enables
ds1 [n|all] ........Display/Set DS1 n=1..2 or all DS1s
equipment ..........Display the Equipment List
event ..............Display the next 18 events
exit ...............Exit Command Line Interface
ip .................Display/Set IP Parameters
kill ...............Kill Connection Assignments
log ................Display/Set log enables
loop ...............Display/Set Loopback State
mac ................Display 6 byte MAC addr in Hex
make ...............Display/Make Connection Assignments
name ...............Display/Set Name Configuration
password ...........Change password
ping ipaddr [n] [d] Send IP Ping to ipaddr up to n times
with d ms delay between pings
rs232 ..............Display/Set Optional Data RS-232 Port
screen height [width]Display/Set CRT screen size
snmp ...............Display/Set SNMP System Group Settings
statistics .........Display Statistics
status .............Display Status of Interface(s)
telnet .............Set Telnet Session Configuration
time ...............Display/Set Time: time hr:mm:ss
trap ...............Send Warm Start Trap to SNMP
v35 ................Display/Set V.35
verbose ............Display/Set Command Fill Verbose Mode
version ............Display Version Numbers in System