Carrier Access Access Bank II SNMP - Manual (Page 157)

14-12 9/24/01
0: FXS Loop or Ground Start
1: FXS Ground Start
2: FXS Loop Start
3: FXO Loop or Ground Start
4: FXO Ground Start
5: FXO Loop Start
6: E&M Immediate Start
7: E&M Wink Start
8: E&M Wink Start ANI/DNIS
9: E&M DPT
type ............... Display DNI Channel Type
s:c [n] opt ...... Set Channel Type for [n] channels from s:c
clear -- for data or bypass
voice -- for voice signaling
dialout .............. Display/Set dialout alarm enables
all on|off ......... Set all alarm enabless
pager .............. Display/Set pager device strings
““ ““ ............ Disable pager device
“phone” “msg” .... Dial phone and msg (blanks ignored)
printer ............ Display/Set printer device strings
““ ““ ............ Disable printer device
“phone” “notify” . Dial phone, report for “notify”
“DIRECT” “notify” Direct connect report for “notify”
sys ................ Display/Set system alarms
power on|off .. Hard reset or power on detected
brownout on|off .. Brown out detected
reset on|off .. Soft reset detected
vn ................. Display/Set alarm enables for V.35 #n
rts on|off .. Loss of V.35 RTS
llb on|off .. Local Loop Back detected
v54 on|off .. Remote V.54 Loop Back detected
dn .....................Display/Set alarm enables for ds1 #n
carrier on|off .... Loss of carrier detected
csuloop on|off .... CSU loop code received
unframed on|off .... Unframed, all 1’s received
sync on|off .... Loss of sync
yellow on|off .... Yellow alarm received
bpv on|off .... BPVs exceed 1544 in 15 min period
ses on|off .... SES exceed 10 in 15 min period
unavail on|off .... Unavailable seconds in 15 min period
fdlline on|off .... FDL line loop request received
fdlpay on|off .... FDL payload loop request received
ds1 [n|all] .......... Display/Set DS1 n=1..2 or all DS1s
circuitid “id” ..... DS1 Circuit ID
csu ................ Set DS1 CSU
off .............. Do not respond to CSU code
on .............. Respond to CSU code
lbo ................ Set DS1 Line Build Out