Cisco 15327 - Manual (Page 467)

26-35
Ethernet Card Software Feature and Configuration Guide, R7.2
Chapter 26 Configuring IEEE 802.17b Resilient Packet Ring
Configuration Examples for Cisco IOS CLI Portion of End-to-End RPR-IEEE
Configuration Examples for Cisco IOS CLI Portion of End-to-End RPR-IEEE
The following examples show RPR-IEEE configurations. Example 26-7 is a simple configuration. It
does the minimum needed to bridge the ML-Series card’s Ethernet ports and the ML-Series card’s
RPR-IEEE and leaves the RPR-IEEE characteristics at default.
Example 26-8 is a complex example of
RPR-IEEE with multiple bridge groups, configured characteristics, and QoS.
Example 26-7 Configuration Example for Simple RPR-IEEE
version 12.2
no service pad
service timestamps debug datetime msec localtime
service timestamps log datetime msec localtime
no service password-encryption
service internal
!
hostname ml
!
boot-start-marker
boot-end-marker
!
enable password x
!
clock timezone PST -8
clock summer-time PDT date Apr 2 2006 2:00 Oct 29 2006 2:00
ip subnet-zero
no ip routing
no ip domain-lookup
!
no mpls traffic-eng auto-bw timers frequency 0
!
bridge irb
!
!
interface GigabitEthernet0
no ip address
no ip route-cache
no ip mroute-cache
bridge-group 10
bridge-group 10 spanning-disabled
!
interface GigabitEthernet1
no ip address
no ip route-cache
no ip mroute-cache
shutdown
!
interface RPR-IEEE0
no ip address
no ip route-cache
rpr-ieee fairness mode aggressive
!
interface RPR-IEEE0.10
encapsulation dot1Q 10
no ip route-cache
no snmp trap link-status
bridge-group 10
bridge-group 10 spanning-disabled
!
ip classless
no ip http server