Lab.gruppen PLM 20K44 - Manual (Page 153)

148
Lake Controller Operation Manual Rev 1.5.4
Modules Menu Reference
8.2.13 Input Selection (MY8-LAKE in Simplified View Only)
The MY8-LAKE device has a unique simplified view for the Mesa Frame configuration by default. In this
view the input can be easily toggled between default Host output and AES input. Please refer to “8.2.7.2
Input Mixer” on page 137 and “22.4 I/O Configuration View Mode Options” on page 280 for further
information.
8.2.14 Frame Config/Soft Reset
For Lake-enabled amplifiers this button reads SOFT RESET and resets the device to its factory default state,
without removing any presets stored in the device, and without resetting the networking configuration data
including IP Config, IP Address, Subnet Mask & Dual Redundancy settings.
For LM Series and MY8-LAKE devices, this button reads FRAME CONFIG and provides a sub-menu
allowing the device to be configured as:
▸ CONTOUR (2-Contour Modules for LM Series; 4-Contour Modules for MY8-LAKE)
▸ MESA EQ (4-Mesa EQ Modules for LM Series; 8-Mesa EQ Modules for MY8-LAKE)
▸ CONTOUR/MESA EQ (2-Contour Modules and 4-Mesa EQ Modules - MY8-LAKE)
For all products, configuring or resetting a device via
the Lake Controller retains the current IP address
setting and system/Frame presets.
8.3 Label & Lock
From the Modules menu, tap LABEL & LOCK to view a submenu with functions to label a Module or Frame
and allow a system designer to lock Module and base configurations
8.3.1 Module Label
The Module Label is a user-definable value at the bottom of the Module icon that identifies the Module.
To label a Module:
1. Tap the desired Module icon on the MAIN page.
2. Tap MODULE LABEL, enter a Module name, and tap OK.