Lab.gruppen PLM 20K44 - Manual (Page 180)

Lake Controller Operation Manual Rev 1.5.4
Groups Menu Reference
175
▸ Group 2 (gray) is assigned to a Module that is not a part of the current system configuration.
▸ Groups 3 through 28 are available for use and are not currently assigned to any other Modules.
Tap and drag the scroll bar to the left/right or tap the << or >> buttons to access additional Group icons.
To add a Group to the system configuration, perform the following steps:
1. Tap a Group icon on the scroll bar. The cursor changes to the Group icon.
2. Tap somewhere in the work area to add the Group to your system configuration.
3. Follow the instructions in section 9.3 to assign Modules to the Group.
10.2 EQ/Levels
Tap the EQ/LEVELS button from GROUPS to display the parametric EQ, graphic EQ, and Levels screens for
the selected Group. This function is active only when a Group is selected in the work area.
For detailed information relating to all EQ/Levels functionality, please refer to Chapter 6 on page 64
Module level limits are always adhered to when Group levels are changed. If one Module in the Group
would exceed its level limit as a result of a change to Group data, then the change will not be allowed.
Level limits can be adjusted in Designer Mode.
10.3 Assign
Changes made to the Group EQ/Levels affect only those Modules assigned to that Group. Before assigning
Modules to a Group, make sure the required Modules and Groups are in the work area and navigate to the
Groups menu.
To assign Modules to a Group, perform the following steps:
1. Tap ASSIGN to activate the function.
2. Tap a Group icon. The icon illuminates yellow.
3. Tap each Module icon you wish to assign to that Group. Each Module icon’s border illuminates yellow
indicating it is assigned to the selected Group.