Lab.gruppen PLM 20K44 - Manual (Page 194)

Lake Controller Operation Manual Rev 1.5.4
Network Menu Reference
189
15. Network Menu Reference
This chapter provides information on the Network menu functions in the Lake Controller. For additional
information on network configuration, please refer to chapter 3 and to the separate Lake Network Configura-
tion Guide and Dante configuration literature included in the Lake Controller installation.
15.1 Network
Tap NETWORK to display the network adapters used to connect the Lake Controller to the network. This
feature can be used to switch between network adapters or to work offline.
1. From HOME, tap NETWORK.
2. Tap the required network connection on the scroll bar.
3. Tap SELECT NETWORK, and then tap YES to the warning message.
Figure 15-1: Network Menu
If multiple adapters are enabled, any adapters other than the currently selected adapter may be disabled to
avoid communication errors.
▸ To disable an adapter, tap the desired network adapter in the scroll bar and tap DISABLE NETWORK.
▸ To enable a currently disabled adapter, tap on the desired network adapter and tap ENABLE NETWORK.
The Lake Controller must be running as administra-
tor for the Enable / Disable functions to work.
▸ To update information about the currently selected network adapter, tap the desired network adapter
and tap REFRESH NETWORK.
▸ To enable multiple Controllers to be connected to the same network, tap the desired network adapter
and tap MULTIPLE CONTROLLERS. Please refer to section 15.2 for further details.