Lab.gruppen PLM 20K44 - Manual (Page 223)

218
Lake Controller Operation Manual Rev 1.5.4
Designer Mode Menu Reference
An online Lake Controller and Lake device network
is required for the following tutorial.
19.1.3.1 System Setup for Designer Mode Tutorial
Follow the steps below to prepare for the tutorial.
To access Designer Mode, perform the following steps:
1. From HOME, tap USER PREFERENCES.
2. Tap DESIGNER FUNCTIONS.
3. Tap the Designer Mode button and enter your Designer Mode password if prompted. (If the Designer
Mode button is orange, you are already logged in to Designer Mode.)
4. Tap HOME to return to the MAIN menu.
5. Place the Modules of a factory-reset Lake device in the work area.
To label the Frame and store the system:
1. Tap STORE/RECALL EXIT, then tap LABEL & LOCK.
2. Tap LABEL FRAME, enter ‘Lake’ as the Frame name, and tap OK.
3. Tap HOME, then SYSTEM STORE/RECALL.
4. Navigate to or create a folder in which to store the file.
5. Tap NEW STORE, enter the file name as ‘Designer Mode Tutorial’, and tap OK.
6. Your system configuration is now ready for the following tutorials.
19.2 Designer Mode Security
19.2.1 Security for the Base Configuration
A base configuration file contains EQ, levels, crossover, and HPF/LPF information for a particular speaker
type. A base configuration file can be used to create a standard starting point for a particular make and
model of speaker; this can then be used in a variety of system configurations and fine-tuned using Module
and Group settings.