Pitney Bowes DP50S Color Printer - Manual (Page 143)

4
Remote Maintenance by telnet
Viewing and specifying the time required to re-obtain the parameter obtained from dhcpv6
msh> dhcp6 ooption lifetime [0-65535]
• It can be entered between 0 and 65535 minutes.
• The default is 60 minutes.
• If you specify “0”, you cannot re-obtain the value.
dns
Use the “dns” command to configure or display DNS (Domain Name System) settings.
View settings
The following command displays current DNS settings:
msh> dns
IPv4 DNS server configuration
The following command enables or disables the IPv4 DNS server address:
msh> dns “number” server “server address”
The following command displays a configuration using the IP address 192.168.15.16 on a DNS 1
server:
msh> dns 1 server 192.168.15.16
• You can register IPv4 DNS Server address.
• You can register up to three IPv4 DNS server numbers.
• You cannot use “255.255.255.255” as the DNS server address.
IPv6 DNS server configuration
The following command enables or disables the IPv6 DNS server address:
msh> dns “number” server6 “server address”
• You can register IPv6 DNS Server address.
• You can register up to three IPv6 DNS server numbers.
Dynamic DNS function setting
msh> dns “interface_name” ddns {on|off}
• You can set the dynamic DNS function “active” or “inactive”.
• {on} means “active” and {off} means “inactive”.
• wlan can be specified only when the wireless LAN interface unit is installed.
145
Interface name Interface configured
ether Ethernet interface