Pitney Bowes DP50S Color Printer - Manual (Page 176)

4
4. Monitoring and Configuring the Printer
178
Message Problem and solutions
Could not attach to PServer <printer server
name>
(In the remote printer mode) Connection to the
printserver has not been established. The print
serverhas refused the connection. Check the
print serverconfiguration.
Current Interface Speed: <EhternetI/F speed> Speed of the Ehternet interface (10Mbps, 100
Mbps, or 1Gbps).
Current IPX address <IPX address> Current IPX address
DHCPv6 server not found. The DHCPv6 server was not found. Make sure
thatthe DHCPv6 is on the network.
Duplicate IP=<IP address>(from<MAC ad-
dress>).
The same IP address (IPv4, or IPv6 address)
wasused. Each IP address (IPv4, or IPv6 ad-
dress) mustbe unique. Check the address of the
deviceindicated in <MAC address>.
Established SPX Connection with PServer ,
(RPSocket=<socket
number>,connID=<connection ID>)
(In the remote printer mode) Connection to the
printserver has been established.
Exit pserver (In the print server mode) The print server
functionis disabled because the necessary print
serversettings have not been made.
Frametype=<frame type name> The frame type name is configured to be used on
NetWare.
IEEE 802.11 <communication mode> mode Displays Wireless LAN communication mode
(infrastructure, or 802.11 ad hoc).
IEEE 802.11 Card does NOT support WPA . A wireless card that does not support WPA isin-
stalled. Install a wireless card that supports WPA.
IEEE 802.11 Card Firmware REV.<version> Displays the version number of the 802.11
card’sfirmware.
IEEE 802.11 current channel <channel number>
Displays the current channel number of the
activewireless card (in ad hoc and infrastructure
mode).
IEEE 802.11 MAC Address = <MAC address>
Displays the MAC address of the wireless inter-
face.