Pitney Bowes DP50S Color Printer - Manual (Page 34)

1
36
1. Preparing for Printing
2. Click the [PostScript] tab.
When using Windows 2000/XP/Vista, Windows Server 2003/2003 R2/2008, click the [Device
Settings] tab, and then proceed to step to clear the check box.
3. Click [Advanced].
4. Clear the [Send CTRL+D before job] and [Send CTRL+D after job] check boxes, and then click [OK].
5. Click [OK] to close the printer properties dialog box.
Form Feed
Do not use NetWare to configure form feed. Form feed is controlled by the printer driver on Windows.
If NetWare form feed is configured, the printer may not print properly.
Follow the procedure below to disable form feed according to the operating system used:
• Under Windows 2000/XP/Vista, or Windows Server 2003/2003 R2/2008, clear the [Form feed]
check box on the [NetWare Settings] tab in the printer properties dialog box.
Banner Page
Do not use NetWare to configure a banner page.
Follow the procedure below to disable banner pages according to the operating system used:
• Under Windows 2000/XP/Vista, or Windows Server 2003/2003 R2/2008, clear the [Enable ban-
ner] check box on the [NetWare Settings] tab in the printer properties dialog box.
Printing after Resetting the Printer
Printer to print server connection requires 30 to 40 seconds to resume after the printer is reset. Dur-
ing this period, jobs may be accepted (depending on NetWare specifications) but not printed.
To print after resetting the printer as a remote printer, check on the print server that the remote
printer is disconnected, or wait for two minutes before trying to print.