BINDER CB 60 User Manual
Operating manual, Apt.line™ cb (e6) co, Incubators co
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- EG – declaration of conformity
- Product registration
- 1. Safety
- 1.1 Legal considerations
- 1.2 Structure of the safety instructions
- 1.3 Localization / position of safety labels on the unit
- 1.4 Type plate
- 1.5 General safety instructions on installing and operating the CO2 incubator
- 1.6 Precautions when working with gases
- 1.7 Precautions when handling gas cylinders
- 1.8 Intended use
- 2. Unit description
- 3. Completeness of delivery, transportation, storage, and installation
- 4. Installation and connections
- 5. Start up
- 6. Functional overview of the T4.12 chamber controller
- 6.1 Menu structure
- 6.2 Operating modes
- 6.3 Deactivating the O2 control and O2/N2 pressure alarms (unit with O2 control)
- 6.4 Humidity control of the Permadry™ system
- 6.5 Turning on / off the interior socket voltage (with optional interior socket)
- 6.6 Performance during and after power failure
- 6.7 Information
- 7. Setpoint entry
- 8. Key lock
- 9. General controller settings
- 9.1 Setup wizard
- 9.2 Date and time settings
- 9.3 Selecting the menu language of the T4.12 controller
- 9.4 Setting display brightness
- 9.5 Changing the temperature unit
- 9.6 Defining the data recording rate
- 9.7 Factory reset
- 9.8 Network configuration
- 9.9 Display of the network configuration
- 9.10 MAC Address
- 9.11 RS 422 address (with optional RS 422 interface)
- 9.12 Display and entry of the device configuration – for service purpose
- 10. Data transfer via USB interface
- 11. Notifications and Alarms
- 12. Event list
- 13. Graphical display of the measured values
- 14. Temperature safety devices
- 15. Options
- 15.1 Communication software APT-COM™ 3 DataControlSystem (option)
- 15.2 RS 422 interface (option)
- 15.3 Silicone access ports 30 mm / 1.18 in, closable from both sides with silicon plugs (option)
- 15.4 Interior socket 230V (option)
- 15.5 Analog outputs for temperature and CO2 (option)
- 15.6 Access port for extra-low voltage (option)
- 15.7 BINDER Gas Supply Service – External bottle changer for CO2, N2 or O2 (option)
- 15.8 Stands
- 16. Reference measurements
- 17. Avoiding microbial contamination
- 18. Cleaning, decontamination / disinfection, and sterilization
- 19. Maintenance and service
- 20. Disposal
- 21. Troubleshooting
- 22. Technical description
- 22.1 Factory calibration and adjustment
- 22.2 Over current protection
- 22.3 Definition of usable volume
- 22.4 CB technical data
- 22.5 Equipment and Options
- 22.6 Spare parts and accessories
- 22.7 Important conversion data for non-SI units
- 22.8 Conversion table for gas inlet pressures, bar – psi
- 22.9 Dimensions CB 60
- 22.10 Dimensions CB 160
- 22.11 Dimensions CB 220
- 23. Contamination clearance certificate
- Word-Lesezeichen
- Leere Seite