CIRCUTOR CIRe3 Series - Manual (Page 3)

CIR-e 3
Instructions manual Pag. 3 of 50
SAFETY INSTRUCTIONS
Follow the advertences and warnings of the present manual preceded by the following signs.
DANGER: Indicates that there is a risk of serious personal injury or material damage in case
that the instructions of the manual are not followed.
WARNING: Indicates that the user must pay special attention to the remarked point
Death, serious injury, or fire hazard can result from improper connection, handling or
maintenance of this equipment. Avoid manipulation of the equipment while it’s connected to
supply.
Read the manual before connecting the equipment. Follow all instructions for installation and
maintenance of equipment throughout its life. In particular, observe the installation standards
specified in the National Electrical Code of your country.
If the installation of the equipment takes place in areas where there is high voltage equipment
(HV), staff handling equipment in the area, must be trained and authorized to perform actions
in HV facilities.
Use always the required personal protective equipment
To use this equipment safely, it is essential to follow the recommendations contained in the
standards and electrical code of the country in which you are installing the equipment.
If the instructions preceded by this symbol of WARNING are not met or applied correctly, this
can cause personal injury or equipment and / or facilities damage.
Liability limitations
CIRCUTOR, SA reserves the right to make changes, without previous notice, to devices or specifications
of equipment shown in this manual.
The term of the CIRCUTOR guarantee is two years from the date of purchase and is limited to refund of
the purchase price, repair free of charge, or replacement of defective equipment that is returned to
CIRCUTOR post-sales service within the term of the guarantee.
The latest versions of specifications and the most up to date manuals of this equipment are available to
CIRCUTOR SA customers on its web site: www.circutor.com.
Recommendations prior to use
Before handling, modifying the connection or replacing the equipment, the power supply must be
switched off, and the equipment disconnected.
It is important to use only the original connection cables and accessories that are delivered along with the
equipment. These products are specially designed for use with this equipment and comply with current
safety standards.
The manufacturer of the equipment is not responsible for any damages resulting from failure by the user
or installer to heed the warnings and/or recommendations set out in this manual, nor for damages
resulting from the use of non-original products or accessories or those made by other manufactures.
Inspect the work area before install. Do not use the device in dangerous areas or where there is a risk of
explosion. Avoid using the device in wet areas