CIRCUTOR CIRe3 Series - Manual (Page 46)

CIR-e 3
Pag 46 of 50 Instructions manual
9 BATTERY REPLACEMENT
Pre-2012 analyzers have a rechargeable battery. In case of malfunction must plug for 12 hours
to charge the battery. After that must set the time of the analyzer as described in Chapter 13
Setting the time of the analyzer.
To proceed to change the battery, disconnect the scanner from any source of
voltage and current measurement and power
Is recommended change the battery each 5 years. To change the battery (for models from
2012) remove the 7 screws on the back of the analyzer and remove the back cover.
You must respect the position of the battery as shown in the adhesive as shown in the following
picture
After changing the battery of the device must be set the time and an hour. To set the time should
follow the instructions in Chapter 13. Setting the time of the analyzer
User must supply and connect the device to de PC, using the wire communications given with
the device. This cable has one four-pin connector (CIR-e) and at the other end is a DB-9 (PC).
(See instruction manual to verify connections and maximum voltage of the device)