CIRCUTOR CDP-0 - Manual (Page 8)

CDP
8 Instruction Manual
3.- INSTALLATION OF THE UNIT
3.1.- PRELIMINARY RECOMMENDATIONS
In order to use the unit safely, it is critical that individuals who handle it
follow the safety measures set out in the standards of the country
where it is being used, use the necessary personal protective equip-
ment, and pay attention to the various warnings indicated in this in-
struction manual.
The CDP unit must be installed by authorised and qualified staff.
The power supply plug must be disconnected and measuring systems switched
off before handling, altering the connections or replacing the unit. It is dangerous
to handle the unit while it is powered.
Also, it is critical to keep the cables in perfect condition in order to avoid acci-
dents, personal injury and damage to installations.
The manufacturer of the unit is not responsible for any damage resulting from
failure by the user or installer to observe the warnings and/or recommendations
set out in this manual, nor for damage resulting from the use of non-original
products or accessories or those made by other manufacturers.
If an anomaly or malfunction is detected in the unit, do not use the unit to take
any measurements.
Inspect the work area before taking any measurements. Do not take measure-
ments in dangerous areas or where there is a risk of explosion.
Disconnect the unit from the power supply (unit and measuring system
power supply) before maintaining, repairing or handling the unit's con-
nections.
Please contact the after-sales service if you suspect that there is an
operational fault in the unit.