Televes HD DTT STB TV on demand access ZAS Hbb - Manual (Page 54)

54
ZAS Hbb
D. 0 0 1 - All Code scan
If programming using the codes in the enclosed list and
the brand search failed to work then you must next try the
automatic all code scan.
1. Ensure that the remote control is equipped with 2 new
batteries (see step one of easy programming procedure).
2. Switch ON your TV SET.
3. Enter the programming mode.
4. After seeing the 2 flashes and within 5 seconds, enter
the code 0 0 1. After entering the code the LED will flash
twice indicating that the code has been accepted.
5. Press and hold the key until your TV switches off.
Please note that this process might take up to 10 minutes.
During the automatic scanning you can release the
key and test other functions. If no key is pressed within
10 sec. then the automatic code scan will be quitted and
the remote returns to the normal mode, signalising it by
a 2 sec. long lighting of the red LED.
If your TV switches into Stand-By mode during the
automatic process, then immediately remove your finger
from the key and press the OK key to memorize the
found table. The red LED will flash twice to signalise that
the code has been stored.
6. In some cases, during the automatic scanning search, the
remote control might find several codes that appear to
operate your TV etc, however, some of the buttons will
fail to work properly. In this case the remote has found
only a partially compatible code and you will need to
restart the automatic scanning process (steps 2. to 5.)
until a better code is found.
Please note that once the automatic process is restarted,
the remote continues from the last saved code and not at
the beginning of code database.
After all saved codes have been scanned, the LED flashes 5
times and the automatic code scan quits.
Note: In Step 5: During the whole code scan procedure you
can press the key up to 5 times in order to select
previous codes. This can be helpful if you have pressed
the
key by mistake or too long. Press the key to
search forwards again.
E. 0 0 2 - Querying the stored 3-digit code
1. Enter the programming mode.
2. Using the number keys enter the 3-digit query code 0
0 2. The TV LED will flash twice to confirm the entered
code.
3. To query the currently saved code, press “1” for first digit,
“2” for second digit and “3” for third digit.
After each digit key has been pressed, count the number
of times the LED flashes. You can repeat the reading by
pressing “1”, “2”, or “3” until you are sure that you have the
correct code written down.
Note: If the LED does not flash, the respective code digit is 0.
Example:
Press key for hundreds. The LED flashes three times. The
first digit of your 3-digit code is thus 3.
Press key for tens. The LED flashes once. The second
digit of your 3-digit code is thus 1.
Press key for units. The LED flashes six times. The last
digit of your 3-digit code is thus 6.
In this example, the code is thus 316.
The programmed code will be retained during batteries
change.
F. 0 0 0 - Reset the RC
1. Enter the programming mode.
4. Using the number keys enter the 3-digit code 0 0 0. The
LED will flash twice to confirm the entered code.
The RC returns to the default settings (TV not programmed).