Argox AS-9500 - Manual (Page 108)

107
Intercharacter Delay
To remove this delay, scan the Intercharacter Delay bar code,
then set the number of steps to 0. Scan the SAVE bar code.
Note: Intercharacter delays are not supported in USB serial
emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 495 milliseconds may be placed
after the transmission of a particular character of scanned data.
Scan the Delay Length bar code below, then scan the number of
milliseconds and the SAVE bar code. Next, scan the Character to
Trigger Delay bar code, then the 2-digit hex value for the ASCII
character that will trigger the delay
User Specified Intercharacter Delay
Delay Length
Character Trigger Delay
To remove this delay, scan the Delay Length bar code, and set the
number of steps to 0. Scan the SAVE bar code