Argox AS-9500 - Manual (Page 52)

51
Print Contrast
Print Contrast is used to adjust the way the imager reads Matrix
symbols. If an imager will be seeing consistently heavily printed
matrix symbols, then a Print Contrast of 6 may improve the
reading performance. For consistently light printing, a Print
Contrast of 2 may help. After scanning the Set Print Contrast bar
code, set the Print Contrast (from 1-7) by scanning digits from the
inside back cover, then scanning Save. Default = 4.
Print Contrast
Set Print Contrast
*Default
Video Reverse
Video Reverse is used to allow the imager to read bar codes that
are inverted. The “Off” bar code below is an example of this type
of bar code. If additional menuing is required, Video Reverse must
be disabled to read the menu bar codes and then re-enabled after
menuing is completed.
Note: Images downloaded from the unit will not be reversed. This
is a setting for decoding only.
Video Reverse
On