Argox AS-9500 - Manual (Page 36)

35
Indication
Illumination Lights
If you want the illumination lights on while reading a bar code,
scan the Lights On bar code, below. However, if you want to turn
just the lights off, scan the Lights Off bar code.
Note: This setting does not affect the aimer light. The aiming light
can be set using Aimer Modes.
Imager Time-Out
Imager Time-Out powers down the imager after the unit has been
idle for the specified time. To prevent the imager from powering
down, set this time-out to 0. Scan the bar code below, then set the
time-out by scanning digits (from 0 -999,999 ms) from the inside
back cover, then scanning Save. Default = 1 ms.
Reread Delay
This sets the time period before the imager can read the same bar
code a second time. Setting a reread delay protects against
accidental rereads of the same barcode. Longer delays are effective
in minimizing accidental rereads at POS (point of sale). Use
shorter delays in applications where repetitive bar code scanning is
required. Reread Delay only works when in Auto-sense Mode