Argox AS-9500 - Manual (Page 70)

69
Telepen
Telepen Output
Using AIM Telepen Output, the imager reads symbols with
start/stop pattern 1 and decodes them as standard full ASCII
(start/stop pattern 1). When Original Telepen Output is selected,
the imager reads symbols with start/stop pattern 1 and decodes
them as compressed numeric with optional full ASCII (start/stop
pattern 2). Default = AIM Telepen Output.
Message Length
Scan the bar codes below to change the message length. Minimum
and Maximum lengths = 1-60. Minimum Default = 1, Maximum
Default = 60.
<Default All Telepen Settings>
On
*AIM Telepen Output
Minimum Message Length
*Off
Original Telepen Output
Maximum Message Length