Argox AS-9500 - Manual (Page 48)

47
Output Sequence
Output Sequence Example
In this example, you are scanning Code 93, Code 128, and Code
39 bar codes, but you want the imager to output Code 39 1st, Code
128 2nd, and Code 93 3rd, as shown below.
Note: Code 93 must be enabled to use this example.
You would set up the sequence editor with the following command
line:
SEQBLK62999941FF6A999942FF69999943FF
The breakdown of the command line is shown below:
SEQBLKsequence editor start command 62 code identifier for
Code 39 9999 code length that must match for Code 39, 9999 = all
lengths 41 start character match for Code 39,
41h = “A” FF termination string for first code
6A code identifier for Code 128 9999 code length that must match
for Code 128,
9999 = all lengths 42 start character match for Code 128,
42h = “B” FF termination string for second code
69 code identifier for Code 93
9999 code length that must match for Code 93,
9999 = all lengths 43 start character match for Code 93,