Argox AS-9500 - Manual (Page 50)

49
Output Sequence
Require Output Sequence
When an output sequence is Required, all output data must
conform to an edited sequence or the imager will not transmit the
output data to the host device. When it’s On/Not Required, the
imager will attempt to get the output data to conform to an edited
sequence, but if it cannot, the imager transmits all output data to
the host device as is. When the output sequence is Off, the bar
code data is output to the host as the imager decodes it.
Note: This selection is unavailable when the Multiple Symbols
Selection is turned on.
Output Sequence Editor
Enter Sequence
Default Sequence
Require Output Sequence
Required
On/Not Required
*Off