Argox AS-9500 - Manual (Page 61)

60
Interleaved 2 of 5
Check Digit
No Check Digit indicates that the imager reads and transmits bar
code data with or without a check digit.
When Check Digit is set to Validate, but Don’t Transmit,
the unit only reads Interleaved 2 of 5 bar codes printed with
a check digit, but will not transmit the check digit with the
scanned data.
When Check Digit is set to Validate and Transmit, the imager
only reads Interleaved 2 of 5 bar codes printed with a check digit,
and will transmit this digit at the end of the scanned data.
Message Length
Scan the bar codes below to change the message length. Minimum
and Maximum lengths = 2-80. Minimum Default = 4, Maximum
Default = 80.
<Default All Interleaved 2 of 5 Settings>
*On
*No Check Digit
Validate and Transmit
Maximum Message Length
Off
Validate , but Don
’t Transmit
Minimum Message Length